Replacing garage door springs is a common maintenance task for homeowners looking to keep their garage doors in optimal condition. In this article, we’ll provide a step-by-step guide on how to replace garage door springs safely as a DIY project.
Step 1: Gather Necessary Tools and Materials:
Before starting the replacement process, gather all the necessary tools and materials. You’ll need winding bars, vice grips, safety glasses, a tape measure, wrenches, and replacement springs that match the size and weight capacity of your garage door.
Step 2: Identify the Type of Springs:
Garage doors typically use either torsion springs or extension springs. Identify which type of springs your garage door has before proceeding with the replacement process. Torsion springs are mounted above the door, while extension springs are located on the sides.
Step 3: Release Tension on the Old Springs:
Before removing the old springs, it’s essential to release the tension to prevent accidents or injuries. Use winding bars to slowly unwind the tension on the springs, following the manufacturer’s instructions carefully. Secure the springs with vice grips to prevent them from snapping back unexpectedly.
Step 4: Remove the Old Springs:
Once the tension is released, carefully remove the old springs from the garage door. Use wrenches to loosen the bolts and brackets holding the springs in place, then carefully slide them out of their mounting brackets.
Step 5: Install the New Springs:
Carefully install the new springs in the same position as the old ones, ensuring they are securely attached to the mounting brackets. Follow the manufacturer’s instructions for proper installation, including winding the springs to the correct tension.
Step 6: Test the Door Balance:
After installing the new springs, test the balance of the garage door by manually opening and closing it. The door should move smoothly and remain in place when partially open. If the door is unbalanced or uneven, adjust the tension on the springs accordingly until the door operates smoothly.
Step 7: Perform Regular Maintenance:
Once the replacement process is complete, perform regular maintenance on your garage door to ensure continued smooth operation. Lubricate moving parts, check for any signs of wear or damage, and make adjustments as needed to keep your garage door in optimal condition.
Conclusion:
By following these steps and safety precautions, homeowners can safely replace garage door springs as a DIY project. However, it’s essential to exercise caution and follow manufacturer’s instructions carefully to prevent accidents or injuries. If you’re unsure or uncomfortable with the process, it’s always best to seek professional assistance.
Learn more by visiting our Blog or give us a shout for a Free Estimate.
#DIYGarageDoor #GarageDoorSprings #HomeMaintenance #SafetyFirst #DIYProject
